【使用說明】：假如不懂安裝，請詳閱以下說明！
01.Do the following to install this app properly.
02.
03.1) RUN Creo Installation
04.
05.2) When a new CREO window (White background with blue LOGO on center left) opens up, look at the bottom left side of that window BEFORE clicking next.
06.
07.2.1) Write down PTC HOSTID in notepad and copy that number.
08.2.2) Open "ptc_licfile" (unzip WF5_crk_ZWT folder and you will find it) in NOTEPAD.
09.2.3) Press "Ctrl" and "F" key together
10.2.4) Type "00-00-00-00-00-00" in "FIND WHAT" box and click "Find Next"
11.2.5) "00-00-00-00-00-00" will be highlighted.
12.2.6) Delete "00-00-00-00-00-00" and type in YOUR HOSTID (without " ")
13.2.7) Now, click on the "FIND" box and click "Find Next" again and repeat the process. You will have to find ALL "00-00-00-00-00-00" from the "ptc_licfile" There are so many "00-00-00-00-00-00" you will have to replace. Do this until you reach the end of the "ptc_licfile"
14.2.8) Save the "ptc_licfile" (Click YES when replacing old file window pops up)
15.
16.3) Install Creo Elements/Pro and Creo Elements/PRO Mechanica
17.
18.4) After installing, follow the steps listed below.
19.
20.Here is what you have to do after installing the software (assuming you followed the steps until this point).
21.
22.1st - Copy "proe_WF5_Win32_crk" file from unzipped WF5_crk_ZWT folder to the following folder - C:\Program Files\PTC\Creo Elements\Pro5.0\i486_nt\obj --> Double click and press click next > ok > next > ok >......> Finish > ok
23.
24.2nd - Copy "proe_mech_WF5_Win32_#1_crk" file from unzipped WF5_crk_ZWT folder to the following folder - C:\Program Files\PTC\Creo Elements\Pro5.0\mech\i486_nt\bin --> After pasting, double click on it and press click next > ok > next > ok >......> Finish > ok
25.
26.3rd - Copy "proe_mech_WF5_Win32_#2_crk" file from unzipped WF5_crk_ZWT folder to the following folder - C:\Program Files\PTC\Creo Elements\Pro5.0\mech\i486_nt\ptc --> After pasting, double click on it and press click next > ok > next > ok >......> Finish > ok
27.
28.4th - Copy "ptc_distributed_services_WF5_Win32_crk" file from unzipped WF5_crk_ZWT folder to the following folder - C:\Program Files \PTC\Creo Elements\Pro5.0\i486_nt\obj --> After pasting, double click on it and press click next > ok > next > ok >......> Finish > ok
29.
30.DO NOT DELETE YOUR "ptc_licfile" from your extracted crack folder.
